Vehicle Wiring Details for your 2004-2007 Chevrolet Malibu Wiring Diagram
Printer Friendly Version
Listed below is the vehicle specific wiring diagram for your car alarm, remote starter or keyless entry installation into your 2004-2007 Chevrolet Malibu . This information outlines the wires location, color and polarity to help you identify the proper connection spots in the vehicle. Please be sure to test all of your wires with a digital multimeter before making any connections. More information on using a
multimeter and testing wires please see our Technical Support Area.
PART
COLOR
LOCATION
12 VOLT
CONSTANT
RED/BLACK (+)
@ BCM, C3, PIN D1, SEE NOTE #2
STARTER
SEE NOTE #1
STARTER
2
N/A
IGNITION
1
PINK (+)
@ IGNITION SWITCH HARNESS or BCM, C4 RED PLUG, PIN D3, SEE NOTE #2
IGNITION
2
N/A
IGNITION
3
N/A
ACCESSORY/HEATER BLOWER 1
BROWN (+)
@ IGNITION SWITCH HARNESS or BCM, C4 RED PLUG, PIN C8, SEE NOTE #2
ACCESSORY/HEATER BLOWER 2
N/A
KEYSENSE
N/A
PARKING LIGHTS ( - )
BROWN/WHITE (-)
@ HEADLIGHT SWITCH or BCM, C2 GRAY PLUG, PIN 5, SEE NOTE #2
PARKING LIGHTS ( + )
BROWN (+)
IN DRIVERS KICK or BCM, C3 RED PLUG, PIN A7, SEE NOTE #2
POWER LOCK
SEE NOTE #1
POWER UNLOCK
SEE NOTE #1
DOOR TRIGGER
GRAY/BLACK (-)(DRIVERS) and TAN/WHITE (-)(PASSENGER) SEE NOTE #3, USE BOTH!!
@ EACH KICK PANEL or BCM, C1 GRAY PLUG, PINS 51 and 72, SEE NOTE #2
DOMELIGHT
SUPERVISION
GRAY (-)
@ BCM, C3 RED PLUG, PIN A10, SEE NOTE #2
TRUNK RELEASE
BROWN/WHITE (-)
@ TRUNK RELEASE SWITCH or BCM, C1 GRAY PLUG, PIN 71, SEE NOTE #2
SLIDING POWER DOOR
N/A
HORN
TAN (-)
@ HORN SWITCH or BCM, C1 GRAY PLUG, PIN 14, SEE NOTE #2
TACH
Any wire NOT PINK (AC)
@ ANY FUEL-INJECTOR
WAIT TO START LIGHT
N/A
BRAKE
WHITE (+)
@ BCM, C1 GRAY PLUG, PIN 42, SEE NOTE #2
FACTORY ALARM DISARM
DISARMS WITH FACTORY REMOTE ONLY!!
ANTI-THEFT
GM'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See NOTE #1
EXTRA
INFORMATION
NOTE #1: This Vehicle Requires a Special INTERFACE BYPASS MODULE for the MULTIPLEX Ignition System and Anti-theft System this also includes the Keyless Entry System, Part # DB-ALL is required for the 2004-2006 vehicles, and for the 2007, the part # DB-ALL or XK09, either will work, to order please go to the INTERFACE BYPASS MODULE Page on this website. NOTE #2 The BCM is part of the FUSE/RELAY BOX, on the Front Passenger side of the Center Console. The BCM has 4
connectors: C1, 72-PIN, GRAY PLUG, C2, 72-PIN GRAY CONNECTOR, C3, 41-PIN RED PLUG and C4, 68-PIN, LT. GRAY PLUG NOTE #3: When installing an Alarm System use both wires and diode isolate.
